Labnet Mini LabRoller Dual Format Rotator Manual de usuario descargar pdf (Pagina 2)

1.0 GENERAL SPECIFICATIONS

Electrical requirements:

115 volt model 115V ±10% 50/60Hz, 0.03A

230 Volt model 230V ± 10% 50/60Hz, 0.015A

Speed:

115 volt model 24 rpm

230 Volt model 20 rpm

Motion Rotating

Maximum Capacity

H5500-02 36 x 1.5ml or 2.0 ml tubes

H5500-15 10 x 15ml tubes

12 x 5/7ml tubes

H5500-50 6 x 50 ml tubes

Dimensions WxLxH 21.3 X 10.2 X 12.6 cm

Included accessories Rotisserie 36 x 1.5ml or 2.0 ml tubes

(H5500-02)

Weight 0.8 kg

Operating conditions 4ºC to 65ºC, up to 85% RH, non-

condensing

2.0 INSTALLATION OF THE ROTATOR

2.1 UNPACKING

Before starting the installation, carefully examine the rotator:

 Open the box and carefully remove the padding. Check to see that

the rotator has not been damaged during transportation. Keep the

packing material until you are sure the rotator works properly.

 Make sure that all of the accessories are included.

 Carefully lift the unit from the box.

 Be sure that the following information is included on the serial number

located on the bottom of the unit: Serial number, Product number,

Electrical rating.

 Check that the power cord has the correct configuration that matches

the outlet according to your local standards.

If any damage occurred during transportation, contact your carrier

immediately.

2.2 STARTING UP THE ROTATOR

Place the rotator on a level and stable surface. Connect the plug into a

grounded outlet. Avoid lines where line surges may occur, i.e.

refrigerators and similar devices are connected, Use the on/off switch to

control the rotator.

1 2 3 4 5 6 7 8

Sin comentarios

Labnet Mini LabRoller Dual Format Rotator Manual de usuario Pagina 2