Labnet Spectrafuge 16M Microcentrifuge User Manual Manual de usuario

Instruction ManualLabnetSpectrafuge 16M MicrocentrifugeLabnet InternationalPO Box 841Woodbridge, NJ 07095Phone: 732 417-0700Fax: 732 417-1750email:

4.2 Lid releaseOnce the run has been completed and the rotor come to a stop,the lid will open automatically. If the lid does not open auto-matically

4.5 Selection of operating time and momentary operationOperation of the centrifuge begins when the timer knob is turnedclockwise to set a run time.

samples containing phenol or phenol chloroform, the rotorshould be cleaned immediately after use.5.4 DisinfectionShould a spill of infectious materia

Possible reason: Centrifuge is not receiving powerSolution: See “Centrifuge will not start”Centrifuge cannot be started, although power is onPossible

To use this chart, find the radius value on the radius scale. Place theedge of a ruler on the value. Place the right side edge of the ruler on thespe

Notes

Copyright January 2002, Labnet International.All rights reserved.Reproduction without prior written permission is prohibited.Information contained her

Table of Contents1. General Information 1DescriptionSafety precautionsTechnical dataAccessories supplied with unitWarranty2. Installation 2Unpacking

1. General InformationThis manual provides important safety information for the Spectrafugelaboratory microcentrifuge. It should be kept near the ce

1.3 Technical dataDimensionsWidth 8.25 inchesDepth 8.9 inchesHeight 7.6 inchesMaximum speed 14,000rpmMaximum RCF 16,000 x gMaximum volume 18 x 1.5/2.

carrier. Any claims for damage must be filed within 48 hours.The accessories supplied with the centrifuge should be kept withthe instruction manual n

Adapter for 0.4ml tubesOrder no. C-1206Tube measurement 6 x 47mmMax. speed 14,000rpmCentrifuging radius 7.3cmRCF (g-value) 16,000 x gAdapter for 0.2ml

Figure 1. Chamber and motor shaftFigure 3. Loading the rotorFigure 2. Bottom of angle rotor5

3.4 Removing the rotorUsing an adjustable or 1/4 inch wrench (some units are suppliedwith a wrench) loosen the screw and remove the rotor retainingsc